من اول يه كابل ساختم (كابل Rs 232-c ) که البته یه کابل سریال بود که دو طرفش مادگی خورده بود و طبق دستور سایت من پین 2 و 3 رو مخالف هم لحیم کردم...
بعدش کابل رو وصل کردم و نرم افزار رو اجرا کردم ...
روی رسیور اعداد از 1 تا 183 رفت و بعدش SUCC نوشت ( یعنی موفقیت آمیز) بعدشم فایل دوم رو که ریختم اسکن قبلی رو پاک کرد و ریسیور صفر ( ریست) شد...
بعدش اسکن کردم ...
اما بازم همون کانال ها رو آورد...
اینم دستورش که از همون سایت استرانگ گرفتم
SRT 4710
1. Please check the serial number of your receiver. It should start by SDE2KXZZZZZ.
If X is less than 5 please download and save the three following files in a new directory of your hard disk drive:
Download.exe
srt4710a.bin (updated on the 06/09/00)
adcl1.bin (updated on the 20/05/03)
If X is equal to or greater than 5 please download and save the three following files in a new directory of your hard disk drive:
Download.exe
srt4710b.bin (updated on the 20/05/03)
adcl1.bin (updated on the 20/05/03)
2. Go to the directory where you have saved the three files and double click on Download.exe
A window named DownLoader V_1.00 will open
3. Prepare a RS-232C line and connect your PC to the receiver
(Pin2 and 3 in the RS-232C line should be twisted)
side 1 side 2
pin 2 pin 3
pin 3 pin 2
4.
5. Turn off AC power or plug out AC power line
To upgrade the unit's software
6. In the DownLoader V_1.00 window, choose Open from the File menu and select the file srt4710a.bin or srt4710b.bin from the directory where you have saved the 3 files. Select the Com Port and press Start.
The message "Connecting OK for STB - Waiting message from STB" will be displayed
7. Turn on AC power or plug in AC Power line
You will see "r1", "r2", "r3" ....."rxxx" on the front panel LED and finally "SUCC" if downloading is finished successfully.
8. Turn off AC power
To download the updated factory default satellite data:
9. In the DownLoader V_1.00 window, choose Open from the File menu and select the file adcl1.bin from the directory where you have saved the 3 files.
NB: This will erase your existing channel list and require a new satellite scan. If you wish to proceed, carry out the following steps:
Select the Com Port and press Start.
The message "Connecting OK for STB - Waiting message from STB" will be displayed
10. Turn on AC power
You will see "r1", "r2", "r3" ....."rxxx" on the front panel LED and finally "SUCC" if downloading is finished successfully.
11. Turn off and on AC power to use the receiver
Print Close
